Rockford-fosgate PCH-14X Manuel d'utilisateur télécharger pdf (Page 11)

Output from

Amplifier

Mounting the Punch Splits Plates

1. Cut the proper size hole for the midrange/woofer and

tweeter. The midrange/woofer hole should be slightly

larger than the mounting plate woofer hole.

2. Place the mounting plate over the mounting holes and mark the

location of the screw mounting holes.

3. Remove the ring. Drill the holes for the screws using a 1/8" drill bit.

4. Mount the speaker plate.

Be careful not to bend the mounting plate during this step.

5. Route the wires through the holes.

6 Attach the wires and be sure to observe the proper speaker polarity.

Keep the speaker wires away from sharp and moving objects.

7. Place the speaker into the hole and snap the speakers into place.

Note: Follow Steps 4 & 5 of Flush Mount Tweeter for tweeter.

– 8 –

• Striped Wire indicates

“+” terminal

of tweeter

CROSSOVER INSTALLATION

® ®

Wiring the PCH-142x

–

®®

ACTIVE TWEETER PROTECTION

PCH-142x

Striped

Wire

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Rockford-fosgate PCH-14X Manuel d'utilisateur Page 11